Liberty Plumbing
Painted illustration of a residential gas meter and black iron riser on an Arizona stucco wall
Plumbing Service

Gas Line Installation & Repair

Adding a casita range, a pool heater, a fire pit, or a generator? Gas work in Maricopa County has to be permitted and pressure-tested, and it's no DIY job. Get it wrong and somebody gets hurt. We install, extend, and repair natural-gas and propane lines, and when you suspect a gas leak anywhere in the North Valley, we move fast. Call us first, then get out of the house.

Book onlineOr call, 24/7(623) 473-0555

Same-day on most calls. Upfront pricing before any work.

What it costs: Quoted by line length, appliance load and the permit the work requires. Leak repairs are flat-rate once the diagnosis locates the fault.

Signs you need gas line installation & repair

  • Rotten-egg smell near an appliance or the meter
  • A hissing sound at a gas connection
  • Adding an appliance that needs a new or extended line

How we handle it

  1. Leak test first

    For a suspected leak we locate and isolate it before anything else.

  2. Size & permit

    New lines are sized for total appliance demand and permitted with the county.

  3. Pressure-test & inspect

    Every line is pressure-tested and inspection-ready before gas is restored.

What to know about gas line installation & repair in Arizona

Gas-line work in Maricopa County is permit-and-inspection territory, not a handyman job. New runs and most repairs need a permit, and the county inspector wants to see a pressure test, typically the line held at 10 psi for a set duration with a calibrated gauge while air, not gas, is in the pipe. We size the line off BTU load and developed length. A tankless water heater pulls 150,000-199,000 BTU and often chokes on the half-inch line a builder ran for an old tank unit, so when you go tankless an upsize to three-quarter or a dedicated run is common.

Material choice matters more than folks think. Black iron is the workhorse for interior runs, but in Phoenix we see a lot of corrugated stainless (CSST) like TracPipe. It's fast to route, but it has to be bonded to the grounding system. An unbonded CSST line is a real lightning-arc puncture risk, and inspectors fail it. Outdoors and underground, code wants coated or poly pipe with proper tracer wire and depth. For high-country cabins in Flagstaff and Prescott running propane instead of natural gas, the regulator, tank distance, and line sizing are different animals, and the orifices in the appliance have to match the fuel.

The honest tell that you need us out is smell plus symptoms: a rotten-egg odor (that's added mercaptan), a hiss near a fitting, dead grass over a buried run, or a pilot that won't stay lit. Don't go hunting the leak yourself with a flame. Shut the gas off at the meter or tank, get everybody out, and call. We find leaks with electronic sniffers and a soap solution, then isolate and repressure-test the section, so we're fixing the actual fault instead of guessing.

Where we earn the flat-rate is on the repair-versus-replace call. A single corroded union or a bad sediment trap is a repair. But a galvanized line that's flaking internally, or a system that fails a pressure test in three places, is telling you the run is done. Patching one leak in a deteriorating line just moves the failure six feet down the pipe. We'll show you the gauge, walk you through what failed, and quote both paths. The decision is yours, and it's made on facts.

Gas Line Installation & Repair across Arizona

We provide gas line installation & repair throughout the Phoenix metro and Northern Arizona high country:

Gas Line Installation & Repair, frequently asked

I smell gas, what now?
Get out of the house, don't flip any switches, and call us (or 911, or the gas utility) from outside. We'll find it and fix it.
Do I need a permit for a fire pit line?
Yes, any new gas line in Maricopa County gets permitted. We handle it.
Do I really need a permit to add a gas line for a pool heater or fire pit?
Yes. Maricopa County and most valley cities require a permit and inspection for new gas runs, including pool heaters, fire pits, and outdoor kitchens. The permit protects you. An inspected, pressure-tested line is documented for insurance and for resale down the road.
My gas water heater is being replaced with a tankless. Is my existing line fine?
Often not. Tankless units fire at 150,000-199,000 BTU versus roughly 40,000 for a tank, so a half-inch line that fed the old heater frequently can't move enough volume. We calculate the load and developed length, and a lot of conversions need a three-quarter-inch upsize or a dedicated run.
I smell a faint gas odor near my range but the detector isn't alarming. What do I do?
Take it seriously. Don't light burners, flip switches, or go looking for it with a flame. If the smell's strong, get out and call your gas utility's emergency line. If it's faint, shut the appliance valve and call us to sniff-test and soap-test the fittings.
What is CSST and why does it need to be bonded?
CSST is corrugated stainless steel tubing, a flexible gas line that routes fast. Because it's thin-walled, a nearby lightning strike can arc to it and punch through the wall, so code says it has to be bonded to the home's grounding system. An unbonded CSST install is a real safety defect, and it'll fail inspection.
How long does a gas line last?
Black iron interior lines can last decades if they stay dry, but galvanized and underground lines corrode and have a finite life. The real answer comes from a pressure test. If a line holds steady it's sound. If it fails in several spots, the run is going, and spot-patching just moves the next leak down the line.

Same-day serviceUpfront pricing before any work